DPS Telecom D-PK-NGBSM, Руководство пользователя, Страница: 20 / 76

16
...via LAN 7.2
NetGuardian BSM Ethernet Port
To connect to the NetGuardian BSM via LAN, all you need is the unit's IP address (Default IP address is
192.168.1.100).
If you DON'T have LAN, but DO have physical access to the NetGuardian BSM, connect using a LAN
crossover cable. NOTE: Newer PCs should be able to use a standard straight-through LAN cable and handle the
crossover for you. To do this, you will temporarily change your PC's IP address and subnet mask to match the
NetGuardian BSM's factory default IP settings. Follow these steps:
1. Get a LAN crossover cable and plug it directly into the NetGuardian BSM's LAN port.
2. Look up your PC's current IP address and subnet mask, and write this information down.
3. Reset your PC's IP address to 192.168.1.200 . Contact your IT department if you are unsure how to do this.
4. Reset your PC's subnet mask to 255.255.0.0 . You may have to reboot your PC to apply your changes.
5. Once the IP address and subnet mask of your computer coincide with the unit, you can access the unit via
a Telnet session or via Web browser by using the unit's default IP address of
192.168.1.100 .
6. Provision the NetGuardian BSM with the appropriate information, then change your computer's IP
address and subnet mask back to their original settings.
Now you're ready to do the rest of your configuration via LAN. Plug your LAN cable into the NetGuardian BSM and
enter your username and password.
NOTE : Default username is admin and password is dpstelecom .