DP Megacontrol Series, Инструкция по установке и эксплуатации

Страница: 33 / 72

33
10 Parameters
10.1 Parameter list
The parameters of the main menu are related to the standard (default) settings of the installation. The standard
(default) settings can be adjusted where necessary and may also be reset whenever required. On the basis of the
standard set parameters, an installation will operate as it should. Additional, extra parameters may be used, e.g.
those under 'advanced', 'pressure', 'delays' and 'clock'. In order to use these additional parameters, you should
activate the corresponding sub menus.
ATTENTION
For unit-specific values see: 'Factory settings'.
ATTENTION
Certain parameters are not visible, depending on the configuration.
Table 38: Access level parameter list
10.1.1 Operation (Quick access button "pump")
Table 39: Parameter list Megacontrol version 1.7.1
Access level Read Write
Everybody e e
User c c
Service s s
Factory f f
Nobody n
Development d d
Parameter Disp
lay
text Va
lu
e
1
descrip
tio
n
Min./Max
.
Read Wr
it
e
Help
text
1 Operation e n Operating status and information
1-1 System e n Information on the operating status and measure-
ments of the complete system
1-1-1 System pressure e n Actual system pressure (discharge side)
1-1-2 System load e n Actual load in % of all pumps in operation (100%
is one pump full speed)
1-1-3 RDP switch not present
present
e n Presence of a run dry protection signal by means
of a pressure switch or float switch
1-1-4 Inlet pressure e n Actual pressure at the inlet connection (suction
side)
1-1-5 Level content in % e n Actual water level in the receiver tank in % of the
content (Storage tank at suction side)
1-1-6 Level height e n Actual water height in the receiver tank (storage
tank at suction side)
1-1-7 Ambient temp. (WSD) e n Actual ambient temperature when temperature
sensor is available (WSD functionality)
1-1-8 Digital inputs s s Displaying the activity status of all the digital
inputs 0 = not active 1 = active