RS4203 Manual
Chapter 10 - Clipper and Looper Operation and Adjustments
Rev 32, 01/11/13
Copyright © 2013, Tipper Tie, Inc., All rights reserved
67
10.8 Looper Setup and Adjustments
The optional Looper system automatically applies a string loop under the clip for hanging products.
10.8.1 Installing Loops on the Looper
This section provides detailed instructions on installing the loop spool and routing the loop tape. The
sections that follow provide instructions for adjusting the looper system.
Install the Loop Spool and Thread Loops Into the Looper
Install the loop spool so that the loops come off the bottom of the spool, and route the loops as shown in
Detail “H” below. Make sure the tape is fed between the Upper Loop Strip Plate and the Tape Backup
Plate in the bottom right corner of Detail “H”. It is easier to feed the loop in this area if you push the Upper
Loop Strip Plate down. Make sure that you have stripped off loops on the tape so that the loops stop short
of the Strip Plates.
Detail “H” Loop Tape Routing
