Dover Petro Vend FSC3000, Руководство по установке

Страница: 63 / 79

3.2 Dispenser Terminal Control (DTC)
DTC (Dispenser Terminal Control) utilizes the dispenser's built-in card terminal in lieu of a fuel island
terminal and will emulate the fuel island terminal for each fueling position connected to the system. DTC
control requires DPC electronic pump control to function and uses the same conduit wiring.
3.2.1 Technical Specifications
Cabinet Dimensions: 10” H x 12.5” W x 5.7” D (25.4 cm x 31.8 cm x 14.5 cm)
Power Requirements: 115/230 VAC; 50/60 Hz; 1.0/0.06 A
Operating Temperature Range: -40ºF to 122ºF (-40ºC to 50ºC)
3.2.2 Terminal Types
DTC can communicate with the Wayne CAT or Gilbarco CRIND. The DTC interface utilizes a second remote
PCM enclosure.
DTC is an upgrade option to DPC (direct pump control). However, it is only available for remote FSC3000
applications and cannot be pedestal-mounted.
Depending upon the type of dispenser (Wayne/Gilbarco/Gasboy), installation may vary. Wayne DTC and
Gilbarco DTC require additional hardware and are installed in a separate enclosures.
NOTE: If you have an iXPay terminal for EMV (in the newer Helix dispensers) you can only
communicate through Ethernet. The Jade boards of these terminals do not have
RS485/RS232 capability.
3.2.2.1 Wayne CAT (Card Authorization Terminal)
The DTC board has RS-485 ports to communicate directly to the Wayne CATs. Up to 12 fueling points can
be controlled. This can be six (6) dual-sided dispensers, 12 single-sided dispensers, or any combination
thereof.
3.2.2.2 Gilbarco CRIND (Card Reader in Dispenser)
In addition to the DTC board, Gilbarco requires a second Electronic Handle Monitor (EHM) board to provide
the isolation and to convert the RS-232 output from the DTC board into the current-loop communication
required by the CRINDs.
CRINDs can connect directly to the Electronic Handle Monitor board or the Gilbarco distribution box. If
connecting directly to the interface board, up to eight (8) dispensers can be connected and a maximum of 12
fueling points can be controlled. For example, the system can control six (6) dual-sided dispensers (12
fueling points), eight (8) single-sided dispensers (8 fueling points), or a combination thereof, such as four (4)
dual-sided and four (4) single-sided dispensers (12 fueling points).
If the distribution box is used, then a maximum of 12 fueling points may be connected. This can be six (6)
double-sided dispensers, 12 single-sided dispensers, or any combination thereof.
M1700 FSC3000 Installation Manual | Dover Fueling Solutions 63