Dover HEIL LIBERTY TP1L-SM-0520, Руководство по обслуживанию

Страница: 21 / 136

Issued May 2020
General Information
Copyright 2020, Heil Environmental
Printed in the U.S.A.
General Information
15
LOCK-OUT/TAG-OUT PROCEDURES
NOTICE
Always use your employer’s Lock-Out/Tag-Out procedures. If your employer does not have Lock-Out/Tag-Out procedures,
use the procedures that follow. Contact your supervisor or Heil Technical Service if you have any questions about Lock-
Out/Tag-Out procedures.
Watch the Service Shack Video online at www.Heil.com/Heil-Service-Shack by selecting Lock-Out/Tag-Out .
Put the unit in a Lock-Out/Tag-Out mode:
BEFORE you enter the unit’s body
BEFORE you do maintenance, repair or cleaning procedures on the unit.
Figure 1. Lock-Out/Tag-Out (Do Not Operate)
Tag
Follow These Steps:
1. APPLY the brakes. MAKE SURE the brakes do not let the unit move and they work properly.
2. Chock all wheels.
3. SET the tailgate props when you raise the tailgate for service, maintenance or cleaning.
4. SET the body props when you raise the body for service, maintenance or cleaning.
5. When there are in-cab controls, turn the ignition switch to ON then:
a. Move the switches of the hydraulic controls. This relieves the pressure in the cylinders.
b. Turn the ignition switch to OFF.
6. When there are no in-cab controls, move the outside control levers to relieve the pressure in the cylinders.
7. Put a LOCK-OUT/TAG-OUT Tag onto the steering wheel.
8. Remove the ignition key from the cab, lock the vehicle, and put the key in a secure location.
9. You can order Lock-Out/Tag-Out Tags (Part Number 212-1586) through your Heil Dealer or through Heil.