Douwe Egberts Cafitesse 700, Руководство для заднего офиса

Страница: 261 / 265

July 2004
5P - 2
Functions -
payment systems
xxx
xxxxxx xxx
xxxx
xxxxxx xx
xxxxxxxx
P.2 Installation – payment systems
• Disconnect the dispenser from the power
supply system and close the water tap.
• Remove the drip tray (1) and the cup
carrier (2). (Fig. 2)
• Open the right dispenser door (3) and
remove the combined trough. (Fig. 1)
• If necessary, remove the cup carrier (4).
(Fig. 1) (See chapter D.2.2)
• Remove the splash panel (5). (Fig. 1) (See
chapter D.2.2)
• Plug the corresponding available cable
harness (6, Fig. 2) into the socket (7,
Fig. 2) in the printed circuit board fixture:
-
use the plug labelled with an "L" if the
payment system on the left-hand side of
the dispenser is to be connected.
- use the plug labelled with an "R" if the
payment system on the right-hand side
of the dispenser is to be connected.
• Remove the stainless steel panel (8) of the
corresponding side wall of the dispenser
and, whenever necessary, remove the
decorative covers (9) first. (Fig. 1)
• Whenever necessary for the installation of
the payment system, remove the corre-
sponding cooling compartment on the right-
hand side or the boiler on the left-hand
side.
• Install the housing of the payment system
on the corresponding side wall of the
dispenser.
In the side wall of the dispenser, drilled
holes are available that can be used
for attachment purposes whenever
necessary.
• Connect the cable harness contacts in the
side wall of the dispenser that have been
for power supply (3-pin) (10) and for data
transmission (6-pin) (11) to the correspond-
ing cable harnesses of the payment sys-
tem. (Fig. 3)
• Complete the dispenser and the payment
system.
• Open the water tap and then connect the
dispenser to the power supply system.
Fig. 1
4
5
3
2
1
8
9
Fig. 2
7
6
Fig. 3
11
10
Cafitesse 700 - Functions - payment systems