Douglas Dynamics WESTERN IMPACT, Руководство пользователя

Страница: 17 / 24

Lit. No. 74236/74237/74238, Rev. 00 17 September 1, 2020
OPERATING YOUR SNOWPLOW
CHECKING HYDRAULIC FLUID LEVEL
1. Park the vehicle on a hard, level surface. Lower
the blade to the ground.
2. Remove the breather/ fi ll plug.
NOTE: Remove breather/ fi ll plug slowly to relieve
any pressure in reservoir.
3. Check the fl uid level in the reservoir. The fl uid
level should be 1/2" to 1" below the top of the
reservoir. Add the recommended hydraulic
fl uid, if
necessary. Do not over fi ll.
4. Reinstall the breather/ fi ll plug.
For hydraulic fl uid type and fi lling instructions, see the
fl uid change instructions under "Hydraulic System" in
the Maintenance section of this manual.
CAUTION
Do not mix di ff erent types of hydraulic fl uid.
Some fl uids are not compatible and may cause
performance problems and product damage.
Breather/Fill Plug
Drain Plug
Reservoir
PARKING WITH SNOWPLOW ATTACHED
Whenever you park your vehicle, completely lower the
blade to the ground.
TOWING DISABLED OR STUCK VEHICLES
Do not use any snowplow components as an
attachment point when retrieving, towing, or winching
a disabled or stuck vehicle.
WARNING
Lower the blade when the vehicle is parked.
Keep 8' clear of the blade. Temperature
changes could change hydraulic pressure,
causing the blade to drop unexpectedly or
damaging hydraulic components. Failure to
do this can result in serious personal injury.