Lit. No. 52308, Rev. 06
12
May 1, 2021
OPERATIONAL TEST AND FINAL ADJUSTMENTS
CABLE ADJUSTMENT
1. Angle the blade fully left and inspect the area
between the driver-side wing stop and the
driver-side blade rib.
2. If there is a gap between the wing stop and the rib,
skip to Step 3.
If there is no gap, return the blade to the straight
position and loosen the 3/4" jam nut and 3/4" hex
nut on the end of the cable 1/4 turn. Repeat this
adjustment until a gap can be seen.
Rib
Wing Stop
Grease
Fitting
Wing stop must just contact
rib when blade is fully angled.
Rib
3. Return the blade to the straight position and adjust
the hex nut 1/4 turn clockwise. Angle the blade
fully left and inspect the area between the wing
stop and the rib again.
4. Continue making this adjustment until the wing
stop just contacts the rib when the blade is fully
angled left.
