Safety instructions
WARNING:
INTENDED USE
The VTAP50 equipment is intended for use by suitably qualified integrators, who will
integrate the VTAP50 OEM module (PCB) into their own hardware, without any changes or
modifications to the VTAP50 OEM module device. (An optional wallbox case can be
supplied.) Components mounted on the VTAP50 PCB are not user-serviceable. Product
safety has been tested to comply with IEC 62368-1.
WARNING:
ESD PRECAUTIONS
We recommend careful handling and storage of Electrostatic Sensitive Devices (ESDs) during
installation. The VTAP50 OEM module (PCB) should always be protected by static shielding
bags for shipping or storage.
WARNING:
POWER SUPPLY
Use either a MicroUSB to USB cable,
or
the optional captive cable, if any, to connect the
VTAP50 OEM module PCB to a PC. (
Never
connect both at the same time).
Using other cables will invalidate EMC emissions and immunity certifications.
The VTAP50 is rated at 5V DC (typ. 110mA, max 150mA) for power over USB.
VTAP50 OEM MODULE INSTALLATION GUIDE
PAGE II
