Dot Hill AssuredSAN 4004 Series, Руководство по установке и замене FRU

Страница: 52 / 59

52 Procedures
NOTE: See the “4824/4834 controller module — rear panel components” topic within the Setup Guide
for an illustration showing a 10GbE SFP+ installed within the IOM.
Replacing a 1Gb RJ-45 SFP transceiver
This section provides steps for removing and replacing a small form-factor pluggable transceiver connector
used in an Internet SCSI (iSCSI) controller host port. The copper RJ-45 connectors are similar in
appearance to other SFP connectors.
Removing and replacing an RJ-45 SFP consists of the same basic steps described for removing and
replacing an SFP in the preceding FC and 10GbE iSCSI sections. This procedure refers to Replacing a
Fibre Channel transceiver . When reviewing the procedure as it pertains to the 1Gb iSCSI host ports, note
that this particular SFP does not support an optic option for 1 Gb.
NOTE: See the “4824/4834 controller module — rear panel components” topic within the Setup Guide
for an illustration showing an 1 Gb RJ-45 SFP installed within the IOM.
Table 10 Removing and replacing a 1 Gb SFP transceiver
To accomplish this sequential process See the following procedures
1. Remove SFP connector. a. Before you begin on page 49.
b. Verifying component failure on page 50.
c. Removing an SFP module on page 50.
2. Install the replacement SFP connector. Installing an SFP module on page 50.
3. Verify proper operation for the removed and
reinstalled component.
Verifying component operation on page 51.