Dot Hill Systems SANnet II 200, Инструкция по установке, эксплуатации и обслуживанию

Страница: 34 / 186

4-2 SANnet II 200 SCSI Array Installation, Operation, and Service Manual • June 2005
Caution –
When you power off the array, wait five seconds before you power it back
on. If you power the array off and on too quickly, a race condition might occur.
4.1 Converting Your Front Bezel Locks So the Keys
Cannot Be Removed
The bezel on your array has two locks whose keys can be removed when the locks are
in either the locked or open position. It is possible to reconfigure the locks so that the
keys cannot be removed.
Figure 4-1 Front Bezel and Front Bezel Locks of an Array
To change the locks so the keys cannot be removed, follow these steps.
1. Remove the bezel by gently pivoting the swing arms out of their ear sockets.
See “Removing the Front Bezel and Ear Caps” on page 6-9 for step-by-step
instructions on how to remove the bezel.
2. Make sure the key is in the locked position, with the pawl extending horizontally past
the edge of the bezel.
Bezel locks