5.2
Assembly
WARNING!
Danger of crushing
If the product tilts, it can tip over and fall on per-
sons. This can cause serious injuries.
– Do not tilt the product.
– Observe transport instructions
WARNING!
Hovering load
Hovering loads can fall down and cause
serious injuries or death.
– Do not enter the area below hovering loads.
– Wear specified protective equipment.
– Only use approved hoists and stoppers.
– Ensure that the hoists and stoppers have
adequate bearing capacity.
Wall Mounting - Assembling Main Cabinet
Personnel:
Mechanic
Protective equipment:
Use ear protection
Protective workwear
Protective gloves
Safety boots
Requirement:
Have two persons to assemble the cabinet.
Use anchor bolts M 8.
Ensure that the cabinet is seated firmly.
Follow the circuit diagram
Fig. 13: Main cabinet rear side
1. Mark bore holes on the wall.
Bore distances:
550 mm (1)
600 mm (2)
2. Drill holes.
3. Raise cabinet using a suitable hoist.
4. Align cabinet horizontally on the wall.
5. Bolt the cabinet with four M8 screws.
Wall Mounting - Assembling Extension Cabinet
(Optional)
6. Repeat steps 1 to 4.
7. Assemble extension cabinet right aligned to the
main cabinet.
Assemble cabinet with base
Personnel:
Mechanic
Protective equipment:
Use ear protection
Protective workwear
Protective gloves
Safety boots
Requirement:
Have two persons to assemble the cabinet.
Floor is even.
Follow the circuit diagram
1. Raise cabinet using a suitable hoist.
2. Align cabinet horizontally on the base.
Assembly
05/2017
EcoPUC MC - MCU00003EN
15/68
