DÖRR EcoGun 116, Руководство по эксплуатации

Страница: 26 / 44

4. Replace worn out or defective compo-
nents.
Assembling
5.
See that the alignment of the
components to be installed is cor-
rect.
Push in needle carefully into the housing,
until the needle tip comes out in the area
of the trigger.
6. String gland bolt (1).
7. String gland spring (4).
8. String spring guide (3).
9. String needle gland (2).
10. Tighten gland bolt (1) sensitively.
If there are leakages in opera-
tion after you replace the needle
gland seal, you have to tighten
the needle gland seal a little
more.
11. Install needle
Ä 8.3.1 “Replace needle
and nozzle.”.
9 Disassembly and Disposal
9.1 Safety recommendations
WARNING!
Risk of injury due to escaping material
and compressed air
Escaping compressed material can cause
serious injury.
Before carrying out any work:
– Disconnect the system, in which the
spray gun is installed, from com-
pressed air and material supply.
– Secure the system against reconnec-
tion.
– Relieve the lines.
9.2 Disassembly
Personnel:
Operator
+ additional qualification explosion pro-
tection
Protective equipment:
Use ear protection
Eye protection
Respiratory protection device
Protective workwear
Protective gloves
1. Rinse the spray gun Ä 6.7 “Rinsing”.
2. Disconnect the compressed air supply
and material feed. Secure against recon-
nection.
3. Disconnect all lines.
9.3 Disposal
ENVIRONMENT!
Incorrect disposal
Improper waste disposal threatens the
environment and prevents re-use and
recycling.
– Always dispose of components in
accordance with their characteristic.
Ä 10.7 “Materials used”
– Collect leaked out operating and auxil-
iary materials completely.
– Dispose of operating and auxiliary
materials according to the disposal
provisions in force.
– In case of doubt, refer to the local dis-
posal authorities.
Disassembly and Disposal
05/2018 EcoGun 116 - MSG00017EN 26/44