Dorner 62M005ESBDDEN, Инструкция по установке, эксплуатации и запасным частям

Страница: 7 / 20

851-738 Rev. A 7 Dorner Mfg. Corp.
Brushless DC Motor Control
Installation
Stand Mounting
1. Install spring t-nuts (Figure 5, item 1) into stand t-slot.
Figure 5
Figure 5
2. Partially thread controller mounting bar (Figure
6, item 1) to lower t-nut with screw (Figure 6, item 2) .
Figure 6
Figure 6
3. Install second spring t-nut into stand t-slot.
4. Partially thread controller mounting bar (Figure
7, item 1) to top t-nut with screw (Figure 7, item 2) .
Figure 7
Figure 7
5. Slide controller to its desired mounting location and
tighten both screws.
Wiring
DANGER
SEVERE HAZARD!
Hazardous voltage will cause severe injury
or death. LOCKOUT POWER BEFORE
WIRING.
WARNING
SEVERE HAZARD!
Exposed moving parts can cause severe
injury. DO NOT ATTEMPT ADJUSTMENTS
WITH CONVEYOR RUNNING. LOCK OUT
POWER before removing guards or
performing maintenance.
WARNING
Controller must be properly grounded.
Failure to properly ground control box may
cause injury to personnel.
NOTE
For additional specific wiring information and
schematics, refer to the Oriental Motor
Operating Manual shipped with your
controller.
A
A