1
99152
To program a new transmitter, it is necessary to program the transmitter’s 8 digit code into the vehicle.
A label with an eight-digit number located on the outside of the Dorman remote. (Original remotes will
have this code on the circuit board).
1.
Sit in the driver's seat; close all doors and the rear gate or trunk
2.
Open and close the driver's door one time.
Within 45 seconds
3.
Open and close the driver's door once. Do not remove the key.
4.
Turn the ignition key from LOCK to ON 10 times within 15 seconds.
5.
A chime will sound once, a buzzer will continue to sound and the interior light will continue to
flash until the transmitter codes are completely registered.
***If you do not perform the steps above within 45 seconds an error will occur and neither a chime nor
the buzzer will sound and the interior lamp will not flash. In this event, start all over again.
Within 45 seconds
6.
Open and close the driver's door once within 15 seconds and an electronic tone will sound for
30 seconds. If you do not perform the operations within 15 seconds an error will occur and the
electronic tone will not sound. In this event, perform the registration steps again beginning with # 3
above.
7.
Before the chime stops on the door, press the power door lock button to LOCK the same
number of times as the leftmost digit of the transmitter code. For example, press the LOCK button 8
times if the leftmost digit of the code is 8.
8.
When you have finished entering the number, push to UNLOCK side within five seconds
9.
Repeat steps 7 through 8 for all digits of the transmitter code going from left to right.
10.
When you are finished, within 5 seconds push that LOCK button to UNLOCK one time and then
repeat steps 7 through 9 a second time with the same transmitter code.
11.
When you have entered the eighth digit the second time an electronic tone will sound for 30
seconds or locks will cycle, after the tone or cycle ends start the vehicle then turn off vehicle, remove
key, open and close door and test remote.
12.
Repeat process to progam additional remotes.