INSTALLATION
910TC-WRM & 910TC-WRB
REMOTE RECEIVER AND REMOTE TRANSMITTER
© 2021 dormakaba Canada Inc
www.dormakaba.us • Phone: 1.800.265.6630 • Fax: 1.800.482.9795 • E-mail: [email protected]
IS910TC-WRM-WRB
PCN2006
R07-21GR
1.
Remove power to the unit prior to installing the remote
receiver.
2.
Insert the pins of the remote board into the header of the
button as indicated below. Ensure the pins are aligned and
fully engaged in the header.
3.
Reapply power to the unit.
4.
Once installed, the transmitter and receiver must be paired
to each other for proper operation.
The remote module allows wireless activation of the 910TC button for convenience or installations that
do not allow for wire access.
5.
On the back of the remote board, locate the button and
LED as indicated below.
6.
Press and hold the button on the board until the red LED
comes on, then release.
7
. While the LED is lit, press the button on the transmitter, the
LED will blink indicating the code is being stored.
8.
The red LED will go out to indicate that storing of the code
has been successful.
Up to 5 transmitters can be paired with one receiver by
following the above process.
NOTE:
Should you need to reprogram or delete a transmitter,
all transmitters will be erased and need to be reprogrammed
individually.
To Erase All Units:
press and hold the button on the
back of the board until the red LED comes on.
Continue to hold the button until the LED goes out.
Repeat steps 6-8 to reprogram
