dormakaba USA Inc. System User Guide 7040.1121 Rev E 10/22 | 49
•
Display:
“In Auto Open Sequence”
•
Keypad: Any keypresses will be rejected with corresponding red LED flash and buzzer beep.
4.
After approximately 5 seconds or less:
•
Lock:
All Locks are locked
•
Display:
Blank screen, “In Auto Open sequence” will reappear if a key is pressed
•
Keypad: The keypad will go to sleep. Any keypresses will be rejected with a corresponding red LED
flash and buzzer beep.
5.
At the end of the Lag Time:
•
Lock:
The target lock will open
•
Display:
“Lock X Open”, where X represents the Target Lock being opened
•
Keypad: Green LED flashes 3 times, with 3 high beeps (if buzzer enabled). Any keypresses will be
rejected with a corresponding red LED flash and buzzer beep.
6.
After approximately 3 seconds:
•
Lock:
The Target Lock will lock
•
Display:
Displays the time and date
•
Keypad: Operates normally
7.
Auto Open sequence ends
3.15.1.3 Auto Open Feedback with battery level low or critical
The Auto Open feature works as described in the previous section, with the following differences when the
battery level is low or critical:
Battery Level low
•
If reported by the lock at wake-up, a key press is required to advance to the logon prompting.
•
Battery low warning will appear briefly before the opening of the Target Lock, accompanied by LED
flashes and beeps (if buzzer enabled).
Battery Level critical
•
If reported by the lock at wake-up, no further actions are possible until the battery is replaced.
•
If critical battery level is detected as a result of opening Lock 1, it will be reported when the Keypad
wakes-up to open the Target Lock. The Target Lock will not open, and the Auto Open Sequence is
cancelled. No further actions are possible until the battery is replaced.
3.15.2 Configure Auto Open – Display Keypad
Note:
3.15.1.1 “Auto Open Interactions with other features”
before configuring Auto Open.
Ensure that the target lock has been installed prior to beginning the Auto Open setup
Follow these steps to configure a multi-lock system for Auto Open using a Display Keypad:
1.
Enter an Authorized User ID and Combination.
2.
Navigate through the Main Menu and select “System”.
3.
Select “Locks” from the sub-menu.
4.
Select “Auto Open” from the sub-menu.
5.
If more than two locks are installed, you will be asked to select a lock. To choose a target lock for Auto
Open, press the corresponding number on the Keypad.
Note:
Lock 1 is not available to be selected as the
Target Lock.
