Check UAS Belt
Tightness
Grasp the child restraint
at the belt path
with one
hand. Push and pull the
child restraint from side
to side, forward and back.
The child restraint should
not move more than 2.5
cm (1 in) and the UAS belt should not loosen.
NOTE:
If it moves more than 2.5 cm (1 in.) or if the UAS
belt loosens, try reinstalling the child restraint or try another
seating location.
Secure your child in the child restraint.
54
53
F. Installing Rear-Facing with UAS
Tighten UAS Belt
Push down firmly on the
child restraint and pull
up on the free end of the
UAS belt to tighten.
5.
It may be easier to
tighten the UAS belt
through the belt path
opening as shown.
6.
Connect UAS to Vehicle’s
UAS Anchor Bar
NOTE:
The UAS connector’s
red release button
MUST
face away from child
restraint and the arrows on
connectors
MUST
face up.
Fasten one UAS connector
to the UAS anchor bar in the
vehicle seat bight. Repeat for
other side of child restraint.
4.
To Remove UAS Belt From
Vehicle UAS Anchor Bar
Remove child from child
restraint. Press down firmly
on child restraint and press
the red release button on
each connector and pull
the connector from the UAS
anchor bar.
8.
Rotate Child Restraint to
Correct Recline Angle
For children between 2.3-10
kg (5-22 lb), the bottom level
to ground line must be level
with the ground. For children
between 10-18 kg (22-40
lbs) and are able to sit up
unassisted, rotate the child
restraint between the top and
bottom level to ground lines.
NOTE:
Only if needed, you
may use a rolled towel(s) or
foam noodle(s) under the front
of the child restraint where the vehicle’s seat back meets the
vehicle’s bench seat to get the correct recline angle.
3.
7.
Recheck Recline Angle
Make sure the child restraint
is properly reclined according
to your child’s weight. Repeat
steps 1 through 6 if it is not
reclined properly.
4358-5694 Elite Eng.indd 55-56
4358-5694 Elite Eng.indd 55-56
11/16/11 1:24 PM
11/16/11 1:24 PM