52
51
F. Installing Rear-Facing with UAS
Do not use the vehicle lap or lap/shoulder belt
when using the Universal Anchorage System
(UAS).
Check UAS belt before each use. Use only if the
belt can be tightened properly and securely.
Secure the tether hook to the tether attachment
when used rear-facing.
Do not fasten both UAS connectors on the same
UAS anchor bar in the vehicle.
Fully recline the child restraint and rotate the
child restraint to the correct recline angle that
matches the weight of your child. Do not use any
other recline positions rear facing. Do not rotate
the child restraint beyond the bottom or top level
to ground lines.
Failure to follow these warnings can result in
serious injury or death.
F-3
Installing Rear-Facing with
UAS
Secure Tether Hook
You
MUST
attach the
tether hook to the tether
attachment as shown.
Tighten tether to remove
the slack.
1.
Place Child Restraint in
Vehicle Rear-Facing in
the Back Seat
Fully recline
the child
restraint.
2.
NOTE:
Review your vehicle’s owner manual for UAS belt use.
continued on next page.
Pull UAS Connector Across to
Opposite Side
Reach under pad and pull the UAS
connector across the shell and
out the rear-facing belt path on
opposite side. UAS belt
MUST
be
under pad and
in front of buckle/
crotch strap
.
Do not place belt over child’s legs.
NOTE:
You must use the 1st or 2nd buckle/crotch strap
slots when rear-facing.
F-2
Preparing UAS for Rear-
Facing Use
Pull Pad Off Corners of
Child Restraint
Pull the seat pad off the front
corners of shell.
1.
Routing UAS Belt
Insert the UAS connector with
adjuster through the rear-facing
belt path.
3.
4.
Replace Pad Over Corners
Make sure the UAS belt is not
twisted.
5.
PUSH
1
2
Adjuster
Unhook UAS from UAS
Attachment
Press down firmly on child
restraint and press the red
release button on each
connector and pull the connector
from the UAS attachment.
Remove the UAS from the forward-facing belt path.
2.
4358-5694 Elite Eng.indd 53-54
4358-5694 Elite Eng.indd 53-54
11/16/11 1:24 PM
11/16/11 1:24 PM
