STEP 5
Attach a bottom slat without hole (S) to the bottom side rails (K) with flat head screws (4).
Make sure the slat touches the corner posts (as close to the headboard as possible).
Attach slats (A1) to the bottom side rails (K) with flat head screws (4). Use space block
(C1) to space them out evenly as shown.
Use a Phillips screwdriver (not included) to tighten the flat head screws.
TWIN/FULL BUNK BED
DA1008TFBB-1, DA1008TFBB-2
NOTE:
If you notice that any of the slats (S & A1) are not perfectly flat, be sure to
assemble them so that the slats (S & A1) curves up in the middle and down on the ends.
4
K
K
S
A1
A1
C1
