Furniture Wall Safety Strap
Hardware List
TOOLS NECESSARY: RUBBER MALLET AND PHILLIPS SCREW DRIVER ARE NOT INCLUDED.
NOTE: 5/16" DRILL BIT AND ELECTRIC DRILL ARE NOT PROVIDED.
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE
USING THIS PRODUCT AND KEEP THESE INSTRUCTIONS FOR
FUTURE REFERENCE. IF YOU HAVE ANY QUESTIONS, PLEASE
CALL OUR CUSTOMER SERVICE NUMBER: (800) 295-1980.
TO MOVE THE FURNITURE AFTER THE SAFETY WALL STRAP HAS BEEN INSTALLED, SIMPLY
REMOVE THE SCREW (PART A) FROM THE WALL TO LOOSEN THE SAFETY WALL STRAP.
LONG SCREW 1 PC
METAL BRACKET 2 PCS
SHORT SCREW 1 PC
WALL ANCHOR 1 PC
SAFETY WALL STRAP 1 PC
STEP 1:
LOCATE AND MARK A SPOT ON THE WALL
BEHIND THE FURNITURE (ABOUT 2" to 3" BELOW THE
TOP OF THE FURNITURE), AND SLIDE THE FURNITURE
AWAY FROM THE WALL, ALLOWING YOURSELF
ENOUGH ROOM TO WORK. USING A 5/16" DRILL BIT,
DRILL A HOLE, (ABOUT 1-1/4" DEEP) AT WHERE THE
MARK IS LOCATED.
WARNING: WHEN UPRIGHT, IT IS POSSIBLE THAT THE FURNITURE MAY
TIP OVER. PLEASE INSTALL THE SAFETY WALL STRAP BEHIND THE
FURNITURE TO ENSURE SAFETY.
STEP 4:
TO INSTALL THE SAFETY WALL STRAP (E) TO
THE WALL, INSERT THE LONG SCREW (PART A) AND
THE SAFETY WALL STRAP (PART E) THROUGH THE
METAL BRACKET (PART B) AND SECURE THE SCREW
(PART A) INTO THE WALL ANCHOR (PART D) USING THE
PHILLIPS SCREW DRIVER. AND THEN PUT THE TAIL OF
SAFETY WALL STRAP (E) TO THE HOLE OF SAFETY
WALL STRAP (E) HEAD, PULL IT FOR TIGHTEN THE
STRAP.
STEP 2:
USING A RUBBER MALLET, HAMMER THE
WALL ANCHOR (PART D) INTO THE DRILLED HOLE
UNTIL THE OPENING OF THE WALL ANCHOR (PART D) IS
EVEN WITH THE WALL.
STEP 3:
MAKE A MARK ON THE BACK FRAME OF THE
FURNITURE (AT THE MIDDLE POSITION OF THE TOP
PANEL BACKSIDE, WHERE YOU WOULD LIKE TO
INSTALL THE SAFETY WALL STRAP). INSERT THE
SHORT SCREW (PART C) AND THE SAFETY WALL STRAP
(E) INTO THE METAL BRACKET (PART B), THEN
INSTALL IT INTO WHERE THE MARK WAS MADE WITH A
PHILLIPS SCREW-DRIVER,AS SHOWN IN RIGHT SIDE.
C B D
E
A
B B
Email:[email protected]
A
B
C
E
D
