Doosan P185WDOU-T4F (F89), Руководство по эксплуатации и обслуживанию

Страница: 41 / 196

Lifting, Transporting and Preparation
Preparing for First Use
Failure to follow these instructions could result in serious personal
injury or death.
Personal injury or damage to equipment can result if material is stored
or transported in or on the compressor.
To prepare compressor for first use:
1. Check the compressor and its components for damage. If there is visible damage,
do not operate the compressor! Contact your Portable Power dealer immediately
for assistance.
2. Take inventory of all items included with the compressor and verify that all loose
components and fasteners are accounted for.
3. Attach component parts not already attached.
4. Add fluids as needed and applicable, including fuel, engine oil, and battery acid (if
needed). This is described further in this chapter.
5. Move the compressor to its operating location.
Never operate compressor without first observing all safety warnings and carefully reading
the Operation and Maintenance Manual shipped from the factory with this compressor.
Setting Up the Compressor
Before setting up the compressor, perform the following steps:
• Position as level as possible. The design of these units permits a 10 degree
sidewise limit on out-of-level operation. (See General Data).
• Ensure the compressor is positioned securely and on a stable foundation. Any risk
of movement should be removed by suitable means, especially to avoid strain
on air discharge piping.
• To keep the engine crankcase oil level near the high level mark (when the
compressor is level).
• Ensure the compressor oil level gauge show no more than mid-scale. Do not
overfill either the engine crankcase or the compressor lubricating oil system.
• The side doors must be closed to maintain a cooling air path and to avoid
recirculation hot air.
• Ensure all transport and packing materials are removed.
41