OP000756
4-45
Inspection, Maintenance and Adjustment
Fuel Filter (Spin-On Type)
General Information
Cummins Common Rail Fuel System
The Cummins Common Rail fuel system requires the use of two
fuel filters. The prefuel filter have the following characteristics:
•
water separating
•
30-micron rating
•
hand priming pump
•
chassis mounted.
The pressure side main fuel filter must have the following
characteristics:
•
engine mounted
Remove
Disconnect the wiring harness from the fuel heater, if equipped.
Loosen and remove the fuel filter.
Make sure the seal ring does
not
stick to the filter head.
Remove the ring with an O-ring pick, if necessary.
NOTE:
Both fuel filters must be removed at the same time.
Install new filter. Apply a small amount of oil around filter gasket.
Screw filter on head until gasket contacts head by hand, turn
filter 3/4 - 1 turn more with filter wrench.
FG006241
Figure 65
Figure 66
Figure 67
Содержание DL160
