DoorHan DRIVE SHAFT-50PRO, Инструкция по установке и обслуживанию, Страница: 9 / 18

9
DRIVE PROGRAMMING
6. DRIVE PROGRAMMING
6.1. Upper stroke limitation setting
Wicket opening sensor connection diagram (Х2)
Operation mode 1:
display shows the figure:
«opening» – is caused by the pulse pressing of key
«closing» – is caused by the holding of key
NOTE:
1. When gate is moving to closing pressing of «up» key causes the closing of gate.
2. When gate is moving to opening pressing of «down» key causes the immediate stopping of gate.
3. This mode of operation is recommended when the safety device is absent.
Нажимая «+» и «–», установите полотно в необходимое
верхнее положение
Нажмите «Р» для
сохранения информаци
Нажмите «+»
Нажимая «–» и «+», установите полотно ворот в закрытое
положени е
Нажмите «Р» для
сохранения информации
замигает
Setting is saved only when programming the UPPER gate position.
Upper position shall be programmed before the setting of the lower gate position
6.2. Lower stroke limitation setting
Setting is saved only when programming the LOWER gate position. Upper position shall be
programmed before the setting of the lower gate position
6.3. Drive operation mode selection
There are 6 operation modes of the control unit:
Operation mode 2:
display shows the figure:
«opening» – is caused by the pulse pressing of key
«closing» –
is caused by the holding of key
NOTE:
1. When gate is moving to closing pressing of «up» key causes the opening of gate.
2. When gate is moving to opening pressing of «down» key causes the closing of gate.
Press «+» Press and hold the
key «P» for about
5 sec.
«1» will light up By pressing «+» or «-» select the value of function Press Р to save the
information
Press «+» «2» will light up
Press «+» «3» will light up
By pressing «+» or «-» select the value of function Press Р to save the
information
By pressing «+» or «-» select the value of function Press Р to save the
information