DoorHan DRIVE SHAFT-50PRO, Инструкция по установке и обслуживанию, Страница: 13 / 18

13
DRIVE PROGRAMMING
6.8. Lower gate position fine adjustment
Setting of lower position and escaping from the programming mode shall be performed before the fine
adjustment carrying out!
1. Start the door closing mode after the programming mode escaping. If it is necessary to increase or decrease the
lower gate position the fine adjustment can be performed using MENU 08 .
Press «+»
«8» will light up
Press Р
«0» will be flashing
By pressing «+»
or «-»
Select the value
of function. (the
function is
switched off)
2. There are levels from 1 to 9 for the lower gate position increasing.
Every changing of value changes the gate position by 0.8 cm.
Min. increase of upper limitation = 0.8 cm Max. increase of upper limitation = 7.2 cm
3. There are levels from -1 to -9 for the upper gate position decreasing.
Every changing of value changes the gate position by 0.8 cm.
Min. decrease of upper limitation = 0.8 cm Max. decrease of upper limitation = 7.2 cm
7. DISPLAY INDICATION
means that now the gate is opening/are opened if the drive operation mode is «2».
Factory setting
Press «+» key «1» is displayed Upper gate position is increased by 0.8 cm
Press «–» key «-1» is displayed Upper gate position is decreased by 0.8 cm
Fine adjustment setting depends on the steel shell diameter and method of setting which the user applies
depending on the certain situation.
S S S
After saved the function push
the button «+» Until the display shows «9» Push «P» to save and exit, and then the
display shows the current moving mode
6.9. Save the function setting
After setting, please use the following steps to Save.