DoorHan DRIVE SHAFT-50PRO, Инструкция по установке и обслуживанию, Страница: 11 / 18

11
6.4. Door automatic closing mode setting
Press «+»
«4» will light up Press Р Display shows the
flashing zeros «00»
(automatic closing
is switched off)
By pressing «+» or
«-» select the value
02 – 20 sec, 03 – 30
sec, …, 60 – 600 sec
Press Р to save the of
function: 01 – 10 sec,
information
NOTE: If a signal lamp is installed and automatic closing time is set the signal lamp will start flashing 10 sec before the
automatic closing time countdown. After the time countdown completion the door immediately closes.
Factory setting
«0» value – the canvas is moving up counterclockwise, the canvas is moving down clockwise
«1» value – the canvas is moving up clockwise, the canvas is moving down counterclockwise
CAUTION! If the motor rotation direction is changed the upper and lower gate position shall be resettled.
6.6. Guards adjustment
NOTE:
In this equipment the guards are the protective system with infrared sensors.
«5» will light up Press Р
«0» will be flashing
By pressing «+»
or «-»
select the value of
function
Press Р to save the
information
Factory setting
Select the required mode of photo cells operation in relation to the output contacts:
NO (normally opened) or NC (normally closed).
0 value – NC contacts
1 value – NO contacts
NOTE: There are 3 guards (SE) on the control panel. Only the setting of guard SE1 can be changed.
NOTE: The installed guards shall be adjusted in accordance with safety settings, otherwise the door will not be
able to close and the lower stroke limitation cannot be set.
NOTE: In modes 1, 2, 4, 5 when the door closes and the guard operated the display shows and the door
opens immediately.
In mode 3, 6 when the door closes and the guard operates the display shows and the door stops immediately.
After the guard returns to the normal condition the indication on display disappears and the door continues
closing.
Press «+»
6.5. Motor rotation direction
«6» will light up Press Р
«0» will be flashing
By pressing «+»
or «-»
select the value of
function.
Press Р to save the
information
Press «+»
DRIVE PROGRAMMING
If the selected mode of operation and NC contacts 2 and 3 (terminal X3) no devices are attached then you must install
a jumper between pins 2 and 3 (terminal X3).