DoorHan DRIVE SHAFT-50PRO, Инструкция по установке и обслуживанию, Страница: 10 / 18

10
DRIVE PROGRAMMING
Operation mode 3:
display shows the figure:
«opening» – is caused by the holding of key
«closing» – is caused by the holding of key
Operation mode 4:
display shows the figure:
«opening» – occurs according to logics OPEN STOP CLOSE STOP
«closing» – causes the closing of gate
NOTE:
When gate is moving to opening pressing of “down” key causes the closing of gate.
Operation mode 5:
display shows the figure:
«opening» – occurs according to logics OPEN STOP CLOSE OPEN
«closing» – causes the closing of gate
NOTE:
1. When gate is moving to closing pressing of “”up” key causes the opening of gate.
2. When gate is moving to opening pressing of “down” key causes the closing of gate.
Operation mode 6:
display shows the figure:
«opening» – is caused by the pulse pressing of key
«closing» – is caused by the pulse pressing of key
NOTE:
When gate is moving to closing pressing of «up» key causes the opening of gate.
NOTE: In any operation mode when door is opened or closed pressing of «STOP» key causes the
immediate stopping of gate.