RF Baghouse, Models RFT, RFW, and RFWH
20
Pleated Bag with Snap-In Design
Filter Installation
1. Slowly lower the filter through the tubesheet hole.
Squeezing the filter to get the straps through the
tubesheet may be required.
2. Gently push the flexible urethane top of the filter on
one side until it snaps into the tubesheet hole.
Note: A snapband retainer has been shipped
for each filter. If you do not have these
snapband retainers, call your Donaldson
representative immediately so they can be
sent to you for proper installation.
3. Pinch the snapband retainer in the center to form a
figure “8”.
Push the opposite side of the top of the filter until it is
securely snapped into the tubesheet hole.
