Installation, Operation and Maintenance manual
19
WSO Flex
Depending on the option provided, please apply MS polymer sealant or use the
included gasket.
When using gasket, do not overcompress (more than 50%).
1
2
3
4
5
6
1
WSO Flex collector
2
Hopper
3
Flex-duct collar
4
Flex-duct
5
Inlet collar
6
Clamp
Figure 11: Inlet hopper with flex duct pack
Inlet hopper / impact separator
This option is used on processes that generate a large number of particles. It must
be positioned on a stand or mounted from the ceiling.
Level the unit before tightening any hardware.
1. Raise the unit to a height of approximately 1,5 m.
2. Align the hole pattern of the impact separator with the bottom flange of the
hopper and fasten with bolts, washers and nuts.
Depending on the option provided, please apply MS polymer sealant or use the
included gasket.
