Installation, Operation and Maintenance manual
18
WSO Flex
Teleduct
Teleduct is the default option for the WSO Flex.
Make sure that the gasket is installed as on image.
1
3
2
4
1
WSO Flex collector
2
Teleduct collector side
3
Gasket
4
Teleduct client side
Figure 10: Teleduct
Inlet hopper with flex duct pack
This option is available for mist collectors which are mounted off the machine.
Level the unit before tightening any hardware.
1. Raise the unit to a height of approximately 1,5 m.
2. Align the hole pattern of the flex-duct collar with the bottom flange of the hopper
and fasten with bolts, washers and nuts.
3. Align the top flange of the hopper with the hole pattern on the bottom of the mist
collector and fasten it with the nuts and washers supplied.
4. Fasten the flex-duct to the flex-duct collar using the clamp supplied.
5. Position the inlet collar and trace the inlet opening and hole pattern onto the
machine.
6. Remove the unit and cut out the inlet hole. Drill the hole pattern using a 4 mm
diameter bit.
7. Apply MS polymer sealant to the newly cut hole pattern on the machine. Align
the inlet collar with the opening and fasten the mist collector to the machine
using bolts, washers and nuts.
8. Connect the flex-duct using the clamp supplied.
