29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia
Phone: 02 9554 9600 | Fax: 02 9554 9433
[email protected] | www.domuslighting.com
Installation Manual
Note:
-The lamp must be installed by professional electrician
-Ensure the power supply is switched off before fitting this product
-Do not touch the lamp when in use
-Keep away from hot steam and corrosive gas
Receiver
Input Voltage: 12-24VDC
Current: 4x5A
Output: 4x(60-120W)
Remark: Constant Voltage
Specifications
Remote
Operation Voltage:
4.5VDC
Operation Frequency:
434MHz/868MHz
Remarks:
RF Wireless
Wiring:
•
Please wire the RF colour controller as per below instructions. Domus has included 2 wiring examples. If
you require any more technical information please don’t hesitate to contact our sales off for more technical
information.
Learning/paring function:
•
Please wire as per instructions. (Please make sure that the correct LED driver has been used and is within the
rated power of the controller and LED strip lighting)
•
Please make sure power is on to the CHAMELEON RF dimmer controller.
•
Please make sure batteries have been installed into the RF remote control (Not included)
•
To start the “learning / pairing” process the remote need to come out of “Sleep mode”. To do this simply press
the “ON” button on the RF remote control.
•
Once the “ON” button has been pressed on the RF remote control please press the “Learn Button” located on
the front panel of the receiver. (Only a quick press is required).
•
Next step is to touch the “Colour wheel” on the RF remote control. If the process above has been done
correctly the LED strip lighting will BLINK to confirm correct “Pairing” has been done.
Please note:
If you hold the “Learn Button” down for longer than 5 seconds this will delete the saved ID and the
above process will need to be repeated.
* The CHAMELEON-03 has the ability to work in either MASTER or SLAVE mode to do this please adjust the
jumper socket located besides the power input. The jumper socket is for MASTER or SLAVE mode. If you want
multiple receivers to run in synchronization please set first controller as MASTER (via jumper socket) and other
receivers as SLAVE (via jumper socket).
CHAM-03
Order Code
Product Code
Description
20112
CHAM-03
RF RGBW colour controller
Thank you for purchasing the CHAMELEON-03 RF RGB-RGBW colour controller. The CHAMELEON-03 gives you
the ability to now create effects, colour to suit your application or your mood.
•
Simple touch colour changing via “Touch Sensitive” colour wheel
•
“Fine tune” colour adjustments.
•
1 zone control.
•
RGB or RGBW colour control.
•
MASTER or SLAVE selectable*
•
10 Built-in colour modes.
