Revision: 1.0
Sapphire-BTX Setup Guide
Copyright © 2022 Domo Tactical Communications (DTC) Limited. All rights reserved.
Commercial in Confidence
Page 5-15
5.3.2
LED Display
The IP address of the BTX can be found and edited, if required from the LED display. This can be
useful if the device is not connected via a DHCP server, or the IP address does not match the subnet
of the PC and the IP address settings need to be changed.
Note
: See
Chapter 4
for details of LED display control.
The IP address can be discovered in the Unit page by scrolling down to the IP settings.
Change the
DHCP Mode
setting to
Off
if you want to enter the IP settings manually.
5.4 Open the Web Interface
Once the IP address has been confirmed, open a web browser on a PC device and enter the IP
address of the BTX in the address bar. Alternatively, if running Device Finder, click
Open
on the line of
the device address.
The web interface will open to the Status page.