Domino V100, Руководство по эксплуатации и обслуживанию

Страница: 158 / 291

OPERATION
27864 Issue 1 January 2008
e position of the
the packing machine,
rough 180 degrees.
The illustration below shows the “Position” tab menu.
ead. By entering a minus value the print
ng a positive value will
int away from the middle of the printer.
is too small
.
nted from
ine signal.
d the
only print every other print. The solution to the problem is that instead
of using the traditional Y-Offset, the Start Pulse offset should be used.
This function displaces the print like an ordinary Y-Offset, but does allow the printer
to receive a start signal from the packing machine “firing” in the middle of printing.
Note: The offset is defined in mm (millimetres) for CM types and in ms (milliseconds) for IM
and V400 types.
Run Settings Position
Under the “Position” tab in “RUN SETTINGS” the user can alter th
print, enter a delay for the signal the printer receives from
laterally reverse the print and rotate the print th
1
2
3
4
(1) X-Offset
5
X-Offset displaces the print across the print h
will be displaced towards the middle of the printer, and enteri
displace the pr
Note: The width of the print head must not be exceeded.
(2) Y-Offset
Y-offset is a virtual white space area pre pended to the printout. If Y-offset
there may not be enough time to move the print head into print position
(3) Start Pulse offset
There may be reasons to displace the print in the Y direction, but are preve
doing so by the fact that printing starts in the middle of the packing mach
Should this occur, an error or warning will be displayed on the screen an
machine will
(
158
)