Dometic STIIC, Инструкция по установке и эксплуатации, Страница: 11 / 24

11
EN
STIIC Controller Installation and Setup
6 .3 Configuring the STIIC PLC
Configuring the STIIC PLC is a several step process. To
give the STIIC PLC recognition of the devices available
for control, you must enable the devices installed on the
vessel and disable the devices that are absent from the
vessel.
The STIIC PLC supports two types of room control
thermostats, each with different features. One of the
thermostat differences is the number of fan speeds
available. The room controls on the STIIC PLC must
be configured for a three-speed or five-speed option,
depending on the thermostat installed.
This section describes how to configure the STIIC PLC
by updating the status of a device, setting a fan speed
option for room controls, and when necessary, setting
up a static IP address for network configuration.
6 .3 .1 Using the Touchscreen to Enable/
Disable Devices
1. On the Main screen, tap STIIC CONFIGURATION .
8 Touchscreen Main Screen
2. The STIIC Configuration screen appears. Tap Device
Enable .
9 STIIC Configuration Screen
3. Select the type of device to enable.
10 Enable/Disable Devices Screen
4. Tap Enable or Disable for each device.
11 Refrigeration Enable/Disable Devices Screen
5. For KRAs, in addition to enabling/disabling, enter the
number of boxes per KRA (max. 3 boxes).