14
EN
Operation
Parking Cooler
NOTICE:
If the unit is switched off by the battery
monitor, it means the battery charge level is low. Avoid
repeatedly starting or using the electrical equipment.
Make sure that the battery is recharged. As soon as the
required voltage is available, the system can be operated
again.
If only the power supply voltage is available to the
parking cooler, the system switches off.
1. Enter configuration mode. Refer to “Entering and
Exiting Configuration Mode” on page 13. The
display shows “P.01” and the battery symbol flashes.
2. Press the
List
button to change the setting. The
current setting displays.
3. Use the
Up
or
Down
button to select the voltage
level for low voltage shutdown. The low voltage
shutdown setting can be adjusted in 0.1 V increments
from 10 V to 12.5 V.
I
The level for the low voltage shut-down should not
be set any lower than the minimum battery voltage
required to be able to start the engine under any
conditions. As a rule that should be no less than 11 V.
4. Press the
List
button to save the setting. The set
value is saved and then applied when the system
is restarted. The menu appears and you can select
another menu item by pressing the
Up
or
Down
button.
8 .3 Setting the Unit For
Temperature Display - P .02
The system can display the room temperature in °C or
°F. This parameter can be configured by performing the
following:
1. Enter configuration mode. Refer to “Entering and
Exiting Configuration Mode” on page 13. The
display shows “P.01” and the symbol flashes.
2. Press the
Up
or
Down
button to select the menu
item P.02. The display shows “P.02” and the symbol
is illuminated.
3. Press the
List
button to change the setting. The code
for the current setting is displayed:
• 0 = °C
• 1 = °F
4. Press the
Up
or
Down
button to select the desired
temperature unit.
5. Press the
List
button to save the setting. The set
value is saved and then applied when the system
is restarted. The menu appears and you can select
another menu item by pressing the
Up
or
Down
buttons.
9 Operation
This section describes the RTX 1000’s and the RTX
2000’s operating controls and settings.
9 .1 Understanding the Controls
q
w
e
19
Device Elements
q
Blower Nozzles
e
Control Panel
w
Intake Grill
