EN
Technical data
RC(S)(L)(D)10-Series
18
4.4
Securing the refrigerator
A
I
1. Move the refrigerator into its final location with the front flange sitting tight
against the recess front.
2. Fasten the screws (fig.
, page 7) through the plastic bushings in the sides of
the refrigerator, and further into the wall.
3. Put the caps onto the screw heads.
Installing the control panel of RC10.4P.100
➤
Install the control panel as shown (fig.
5
Technical data
For the current EU declaration of conformity for your device please refer to the
respective product page on dometic.com or contact the manufacturer directly
(see dometic.com/dealer).
This device complies with UN ECE Regulation R10.05.2014.
Depending on the model, the refrigerator uses either R134a or R600a as refrigerant.
Refer to the data plate for the refrigerant used.
For R134a models applies:
This product contains fluorinated greenhouse gases.
The cooling unit is hermetically sealed.
NOTICE! Damage hazard
Only screw through the bushings provided, otherwise foamed compo-
nents, such as cables, can be damaged.
NOTE
•
Attach the side walls or the attached strips so that the screws are
tight, even under increased loads (while driving).
•
The refrigerator is designed to provide a regulated air flow. The man-
ufacturer does not recommend to leave additional space between
the refrigerator and the recess walls.