EN
CS102, CSG103
Cleaning and maintaining the device
17
I
➤
Completely close the valve on the gas cylinder.
➤
Unscrew the regulator from the cylinder.
➤
Check the condition of the gas hose.
Replace the hose line if the material is brittle or porous.
➤
Tightly screw the regulator by hand onto the new cylinder.
7
Cleaning and maintaining the device
➤
Proceed as follows: fig.
➤
Have a suitable authorized and qualified person perform a thorough examination
of the device at least every 5 years.
8
Troubleshooting
Due to unforeseen circumstances the appliance may not operate as designed.
Indications of this are burner flash-backs, large soft yellow flames, flames rising exten-
sively away from the burner and the appliance not igniting or remaining alight.
➤
In these cases, check your gas supply to ensure there is sufficient gas, no leaks
and the valves are opened sufficiently for use. If this is the case and the problem/s
still persist, you will need to contact a suitably qualified authorized person to ser-
vice your appliance.
Repairs to the gas supply parts on the device may only be carried out by a qualified
technician.
➤
Shut off the gas supply immediately if a fault occurs.
➤
Check again that the device has been assembled correctly and the parts are
undamaged, especially the gas hose.
➤
Replace the damaged parts.
➤
Only use the device again once all the faults have been rectified.
NOTE
To check whether the gas cylinder is empty gently rock it while upright
from side to side. If you can hear or feel liquid this indicates the bottle still
contains LPG.
DometicCS102-CSG103_IOM_4445103024_APAC(en)_.book Seite 17 Donnerstag, 9. April 2020 11:02 11
