Dometic CRE0050, Инструкция по установке и эксплуатации

Страница: 31 / 348

EN
CRE Troubleshooting
31
Compressor does not run (battery connection)
Compressor is not running (connected to AC supply)
Problem Possible cause Remedy
U
TERM
= 0 V There is an interruption in the
battery – electronics connection Establish a connection
Main switch faulty (if installed) Replace the main switch
Additional supply line fuse has blown
(if installed) Replace the supply line
fuse
U
TERM
≤
U
ON
Battery voltage is too low Charge the battery
Start attempt with
U
TERM
≤
U
OFF
Loose cables
Poor contact (corrosion)
Establish a connection
Battery capacity too low Replacing the battery
Cable cross section too small Replace the cable (chap-
ter “Connecting the
refrigerator to DC volt-
age” on page 23)
Start attempt with
U
TERM
≥
U
ON
Ambient temperature too high –
Insufficient ventilation Move the refrigerator to
another location
Condenser is dirty Clean the condenser
Electric circuit between
the pins in the compres-
sor interrupted Defective compressor Replace the compressor
U
TERM
Voltage between the positive and negative terminals of the electronics
U
ON
Cut-in voltage of the electronics
U
OFF
Cut-off voltage of the electronics
Problem Possible cause Remedy
No voltage Connection supply line interrupted Establish a connection
Main switch faulty (if installed) Replace the main switch
Additional supply line fuse has blown
(if installed) Replace the supply line
fuse
CRE50-65-80_IOM_EMEA16.book Seite 31 Mittwoch, 30. September 2020 10:50 10