EN
CK155
Cleaning of the fan filter
7
➤
Make a hole with a diameter of 105 mm through the roof of the vehicle.
➤
Place the ventilator part
A
in the hole and mark the six screw holes.
➤
Remove part
A
and apply a thin ring of some permanently plastic sealing com-
pound around each hole.
➤
Put the rubber ring into the groove underneath of part A. It is important that the
lower part is firmly tightened so that the rubber gasket fits closely against the roof.
➤
Fasten the hood
B
in the lower part
A
.
➤
Fasten the upper part
C
in the lower part
A
.
➤
Make a hole in the bottom of the cupboard (fig.
➤
To access the mounting screw holes, remove the lamps.
➤
Fasten the ventilator hood
D
with screws.
➤
Fit the hose to the fan and hood.
➤
Tighten the hose with the hose clips.
➤
Connect the fan to the battery according to the figure.
4
Cleaning of the fan filter
I
➤
Remove the filter and clean it with warm water and a synthetic detergent (such as
washing-up liquid).
NOTE
The filter of the extractor hood must be cleaned regularly, as grease
accumulates here. How often cleaning is necessary depends on how
often you cook and how often the extractor hood is switched on. Do not
wait for the performance of the extractor hood to noticeably decline
before you clean the filter.
DometicCK155_IOM__EMEA(en-de-fr-sv-fi)_.book Seite 7 Donnerstag, 23. Januar 2020 2:46 14
