Dometic BUTTNER MT iQ SolarPRO, Инструкция по установке и эксплуатации

Страница: 9 / 116

MT iQ SolarPRO Scope of delivery
EN
9
A
NOTICE! Damage hazard
• Only use rechargeable batteries.
• Prevent any metal parts from falling on the battery. This can cause sparks or short-cir-
cuit the battery and other electrical parts.
• Ensure that the polarity is correct when connecting the battery.
• Follow the instructions of the battery manufacturer and those of the manufacturer of
the system or vehicle in which the battery is used.
• If you need to remove the battery, first disconnect the ground connection. Discon-
nect all connections and all consumers from the battery before removing it.
• Only store fully charged batteries.Recharge stored batteries regularly.
• Immediately recharge deeply discharged lead batteries to avoid sulfation.
• Check the acid level for open lead-acid batteries regularly.
1.4 Safety precautions when handling lithium batteries
!
CAUTION! Failure to obey these cautions could result in minor or moderate
injury.
Risk of injury
• Only use batteries with integrated battery management system and cell balancing.
A
NOTICE! Damage hazard
• Only install the battery in environments with an ambient temperature of at least 0 °C.
• Avoid deep discharge of the batteries.
2 Scope of delivery
No. in
fig.
1
,
page 3
Description Qty.
1 MT iQ SolarPRO 1
2 Connection cable (5 m) with plug for current sensor and two supply
cables 1
3 Current sensor 1
4 Wall-mounting box 1
5 Tapping screw ISO 7050 – C 2,9 x 9,5 – A2 (PZ) 4
5 Tapping screw ISO 7049 – ST 3,5 x 9,5 – A4 (PH) 4