Dometic 9600026948, Инструкция по установке и эксплуатации

Страница: 12 / 36

12
EN
Door Swing Reversal DMC Refrigeratorss
6 .8 Reinstalling the Fresh Food
Door, Lock, and Middle Hinge
This section describes reinstalling the fresh food door
and middle hinge bracket.
q
w
e
r
15 Reinstalling the Fresh Food Door, Lock, and Middle Hinge
q
Middle Hinge Bracket
e
Fresh Food Door
w
Lock and Lock Screws
r
Pin on Lower Hinge
Bracket
1. Lower the fresh food door into position by aligning
the hole from the door stop bushing onto the pin on
the lower hinge bracket.
I The door’s magnetic seal should hold the door in
place to install the middle hinge bracket.
2. Align the middle hinge bracket at the edge of the
fresh food door, above the lower hinge bracket.
3. Reinstall the middle hinge bracket, but do not fully
tighten the screws.
4. Align the lock assembly on the other edge of the
fresh food door, above the new handle location.
5. Reinstall the lock assembly, but do not fully tighten
the screws.
6. Ensure the door aligns horizontally and vertically,
swings freely, and seals properly on all sides.
7. Tighten all middle hinge and lock assembly screws.
8. Lower the freezer door into position by aligning the
hole from the door stop bushing onto the middle
hinge bracket pin.
I The door’s magnetic seal should hold the door in
place to install the upper hinge bracket.
6 .9 Reinstalling the Upper Hinge
This section describes reinstalling the freezer door and
upper hinge bracket.
q
t
r
w
e
16 Reinstalling the Freezer Door and Upper Hinge
q
Upper Hinge Cover
r
Plastic Screw Cover
w
Upper Hinge Bracket
t
Freezer Door
e
Hinge Screws
1. Align the new upper hinge bracket at the edge of the
freezer door, above the middle hinge bracket.
2. Install the new upper hinge bracket, using the three
hinge screws, but do not fully tighten.
3. Ensure the door aligns horizontally and vertically,
swings freely, and seals properly on all sides.
4. Fully tighten the hinge screws on the upper hinge
bracket and snap the upper hinge cover in place.
5. Reinstall the plastic screw cover on the top where the
old upper hinge was removed.
I If necessary, reconnect the wiring, plug in the
power cord, or turn the breaker on.
6. Return the refrigerator to the enclosure as described
in "Securing the Refrigerator" on page 6.
7. Level the refrigerator as described in "Positioning the
Refrigerator" on page 6.