Dometic 9600014796, Руководство по эксплуатации

Страница: 9 / 124

MCK750 Using the kettle
EN
9
7 Using the kettle
!
A
7.1 Before initial use
A
1. Boil water once or twice to clean the water tank.
2. Pour the boiled water away.
7.2 Boiling water
1. Set down the water tank in a central position on the locking tongues (fig.
3
1, page 3).
2. Turn the water tank 90° anti-clockwise.
3. The lock (fig.
3
2, page 3) must engage audibly.
4. Press the two locking buttons in the lid (fig.
4
2, page 4) together and open the lid.
5. Pour the desired amount of water into the tank.
6. Close the lid.
✔
The lid engages audibly.
7. Check that the voltage specification on the type plate corresponds to that of the energy
supply.
8. Connect the DC plug to a DC socket.
9. Press the On/Off switch (fig.
1
3, page 3) to start the boiling procedure.
✔
The control lamp (fig.
1
4, page 3) is lit up during the boiling procedure.
✔
The kettle is automatically switched off when the water boils.
You can not switch off the kettle by hand.
10.To remove it, press the lock (fig.
5
1, page 4) and turn the water tank 90° clockwise.
CAUTION! Scalding hazard
• Use the device only when the vehicle is stationary, not while it is moving.
• Empty the water tank carefully.
NOTICE! Damage hazard
• Please immediately absorb any escaping fluid. Damage to the electronics may be
caused by moisture entering the device.
• Fill the water tank up to between the minimum and maximum mark (fig.
2
,
page 3)..
NOTICE! Damage hazard
Before connecting the device to the DC power socket, you have to fill the water tank
with water.
DometicMCK750_OPM_4445101700_EMEA17_20xx-xx-xx.book Seite 9 Dienstag, 29. Juni 2021 10:13