7
3311145.000 Secondary Burner Housing Kit Service Instructions
Step
10. Install the boiler cover, Item (5).
The boiler cover is shipped fl at with
two angled edges. It will need to be
formed to fi t around the cooling unit
fl ue jacket. With the angles facing to-
ward you, grasp the side with the pre-
drilled holes in your right hand and the
opposite side with your left hand and
bend the boiler cover toward you and
form a circle approximately 6 inches
in size. Note that additional adjust-
ments to the exact form of the boiler
cover may be necessary.
This will allow you to slide the cover
around the cooling unit fl ue jacket.
If required, pull the leading edge of
cover from behind the cooling unit
fl ue jacket using a pair of long needle
nose pliers or by inserting a 6" plas-
tic tie wrap into the clearance hole on
the fold and fl attened edge. The fold
and fl attened edge of the boiler cover
should extend as shown in the photo
below.
Step 9
Step 9
Step 10
Step 10
Step 10
Step 10
Step 10
Step 10
Boiler cover in position
