USER MANUAL
PTM 216Z – 2.4 GHz Zigbee Generic Switch Pushbutton Transmitter Module
© 2018 EnOcean | www.enocean.com
F-710-017, V1.0
PTM 216Z User Manual | v1.2 | November 2018 | Page 21/43
5.2.2
Radio channel confirmation
Once confirmation about successful commissioning has been received, the radio channel of
the PTM 216Z module that was used for transmission of the commissioning telegram has to
be confirmed so that it will be used for subsequent transmissions of data telegrams as well.
In order to confirm the radio channel, buttons A1 and B0 have to be pressed together as
next action after the transmission of the commissioning telegram.
Note that this step requires that both A1 and B0 buttons can be operated together. This will
be the case when PTM 216Z is integrated into a double rocker or a four button switch de-
sign. Otherwise (e.g. for the case of a single rocker switch design) PTM 216Z would have to
be removed from the housing design first.
Upon press of A1 and B0, PTM 216Z will permanently adjust the radio channel to the one
corresponding to the long pressed button as defined in Table 2 and send a data telegram
(0x69 + button status) on this channel.
If the new radio channel is different from the previously used radio channel then PTM 216Z
will send a decommissioning command (0xE1) on the previously used radio channel upon
release of A1 and B0. If the radio channel remains unchanged then PTM 216Z will send a
data telegram (0x6A + button status) upon release of A1 and B0.
5.2.3
Example of direct commissioning
Consider the case where PTM 216Z should be commissioned into a network or receiver op-
erating on radio channel 15.
To do so, follow these steps:
1.
Long press (for more than 7 seconds) button A0
2.
Verify that the receiver or network received and accepted the commissioning tele-
gram. Otherwise step #1 can be repeated as needed.
3.
Confirm the selected radio channel (channel 15 in this case) for subsequent use by
pressing A1 and B0 together.
5.2.4
Disabling direct commissioning
Direct commissioning can be disabled by pressing A0 and A1 together for more than 7 sec-
onds. Note that for rocker switches this is only possible after removing the rocker and
manually operating the button contacts and the energy bar.
Direct commissioning can be re-enabled by means of a factory reset as described in chapter
5.7.