Dolphin BC100SS, Руководство по установке, Страница: 8 / 26

N A P P Y C H A N G I N G U N I T I N S TA L L AT I O N
Stainless Steel Units
S T E E L U N I T S
Each stainless steel unit can either
be surface-mounted or recessed.
A matching stainless steel cover
frame is available for surface-
mounted installations.
RECOMMENDED MOUNTING HEIGHT TO BASE OF UNIT:
Standard – 900mm
Wheelchair – 750mm
• In all mountings, the flat fender washer must be inserted
underneath the finishing washer: installing the unit using only
the finishing washer may result in the washer biting directly
into the body of the unit with consequent damage and loss
of stability. • Nappy changing units are no stronger than the anchors or
substrates to which they are attached and as such must be
firmly secured in order to support the loads for which they
are intended.
R E C E S S E D F I X I N G I N
M A S O N RY
Each unit has six recess mounting holes.
Form the opening in the brick or
blockwork wall, incorporating an
appropriate lintel to span the opening.
Install rough timber fixing grounds and
screw fix the changing unit to the
reveals of the opening using minimum
5mm screws.
Before final tightening, insert packing
shims as necessary for alignment and to
obviate any distortion on tightening.
Use either flat head screws with
finishing washers and flat washers or
pan head wood screws with flat
washers, making sure that consideration
is given to the operating clearance and
that the back flange of the unit neatly
masks the opening and the termination
of the wall finish.
R E C E S S E D F I X I N G I N
S T U DWO R K
Timber double stud blocking is
necessary around the opening.
After locating the unit within the
framed opening, insert packing shims as
necessary for alignment and snug fitting.
Secure the unit to the blocking using
minimum 5mm flat head wood screws
with finishing washers and flat washers
or pan head wood screws with flat
washers, making sure, as with all fixing
methods, that consideration is given to
the operating clearance.
S U R FAC E M O U N T I N G
The unit can be fixed directly through
the back plate using screws and
appropriate wall plugs and plastic caps
to cover the screw heads.
A matching stainless steel cover frame
is available for surface-mounted
installations which engages the changing
unit with a snap fit. The cover frame
covers the otherwise exposed edges
and provides a neat finishing surround.