9
CAUTION: Before doing any work on the string trimmer, always switch off the
motor and pull the spark plug connector off the spark plug.
Always wear protective gloves.
CAUTION: Start the string trimmer only after having assembled it completely.
Loosen the two bolts (1) and insert the main pipe (2) into the case clutch (3).
–
Insert it up to the arrow-mark position. (Refer to the sketch on the right.)
–
If it is difficult to insert, turn the spline (4) a little and re-insert.
Tighten the two bolts (1) uniformly on the right and left by Allen wrench
–
supplied.
How to mount the control cable
Remove the air cleaner cover.
–
Put the control cable (5) into the adjusting cable (6). Shift the swivel (7) and
–
put the cable into the swivel. At this time, be careful that the round hole in the
swivel is oriented toward the fitting at the inner wire end.
Release the swivel and make sure that the inner wire fitting is placed in the
–
hole.
Mount the air cleaner cover.
–
Connection of the switch cord
Connect the switch cords to the two cords from the engine by inserting one
–
into the other.
Fix the cord connector by clamp.
–
ASSEMBLY OF ENGINE AND SHAFT
(1)
(6)
(7)
Swivel
End fitting
Connector
Control cable
Round hole
(5)
(4)
(3)
(2)
Arrow-mark
