20
Installing the line knife
- The line knife (
D/8
) is attached to the guard with two
screws.
note:
The line knife cuts bith trimmer line to the proper maximum
length after length adjustment (see “lengthening the line”).
The trimmer is delivered with the line knife already installed.
GETTInG STArTED
CAUTIOn:
when doing any work on the trimmer, always switch off the motor, disconnect the power plug, and wear pro-
tective gloves!
CAUTIOn:
Do not start the trimmer until it has been fully assembled and inspected!
A
- Put grip (
A/1
) on shaft tube (
A/2
), Hold the mounting plate
(
A/3
) against it from below and secure it enough to hold
it in place with four screws (
A/4
). Do not yet tighten the
screws.
- Move the grip along the tube until it is in a position that allows
you to work with a comfortable posture.
- Tighten the screws (
A/4
) evenly, alternating sides, until all
are tight.
B
Installing the handle
- Put the guard (
B/5
) on the shaft tube
above
the clamp
(
B/6
) and then push it down towards the trimmer head as
far as it will go.
- Turn the guard 80 degrees (see Fig. C).
C
D
Installing the trimmer guard
- Put on the mounting plate (
C/7
) and secure with four screws.
Tighten the screws evenly, alternating sides, until all are
tight.
1
2
3
4
5
6
7
8
