DOLD Safemaster Pro, Руководство пользователя

Страница: 190 / 200

Configurable Safety System SAFEMASTER PRO
190
0265525 / 16.05.19 en / 101A
SCHEMATIC SIMULATION
Click on the icon to start the schematic simulation.
Schematic simulation can be used to check/guide the output signals of the various function blocks in real-time,
even during the actual simulation. You may choose the block outputs you wish to control and check the response
of the various elements of the schematic model according to the colour of the different lines.
As with the monitor function, the colour of the line (or of the actual key) indicates the signal status: green means
the signal is set to LL1, red means the signal is set to LL0.
With "Schematic Simulation", some new keys appear in the toolbar. These can be used to control the simulation:
the "Play" and "Stop" keys to start and stop the simulation, the "PlayStep" key for step-by-step operation and the
"Reset" key. When the simulation is reset, the Time value is reset to 0 ms.
When you press "Play" to start the simulation, the amount of time that has elapsed is displayed next to the word
"Time". This time is measured in "Step" units of time multiplied by the user-defined "KT" factor.
Schematic Simulation
Click on the bottom right key of each input block to activate the respective output status (even when the simulator
is not running, i.e. when the time is not elapsing: in this case the simulation is "static"). If the key turns red when
you click on it, the output will be set to level LL0. If it turns green, the output will be set to level LL1.
In some function blocks, such as "speed control" or "lock_feedback", for example, the key is grey. This indicates
that the value must be entered manually in a specific pop-up window. The type of value to be entered differs
according to the type of function block (e.g., in a "speed control" block you will need to enter the frequency).