DOLD Safemaster Pro Series, Руководство пользователя

Страница: 4 / 24

UG6951 / UG6952 / UG6954 / UG6955 / UG6956 / UG6957
SAFEMASTER PRO fieldbus modules
2
/
17
0265998 09.05.2017 LA822P
INTRODUCTION
This technical data sheet describes the operation of the fieldbus modules of the configurable safety system
SAFEMASTER PRO:
UG6951 Fieldbus module (CANopen)
UG6952 Fieldbus module (PROFIBUS DP-V1)
UG6954 Fieldbus module (PROFINET)
UG6955 Fieldbus module (Ethernet IP)
UG6956 Fieldbus module (EtherCAT)
UG6957 Fieldbus module (USB)
The fieldbus module exports the system status and the status and diagnostics elements of all I/Os configured on the
SAFEMASTER PRO system.

These fieldbus modules have no influence on the safety functions of the configurable safety system
SAFEMASTER PRO.
ELECTRICAL CONNECTIONS, DIMENSIONS
Each module is provided with four connectors:
- 5 way IN-RAIL-BUS connector to the system SAFEMASTER PRO
- micro USB connector --> to the PC (for SW programming)
- BUS connector --> to the fieldbus
- Terminal block --> power supply
TERMINAL BLOCK
Terminal Signal
1 +24VDC ±20%
2
3
4 GND
Table
1
Figure 1

Install SAFEMASTER PRO modules in an enclosure with a protection class of at least IP54.

The supply voltage to the units must be 24Vdc ±20% (PELV, in compliance with the standard EN 60204-1).

Do not use SAFEMASTER PRO to supply external devices.

The same ground connection (0VDC) must be used for all system components.
22,5mm 109mm
1
2
2
,6
m
m