Procedure
1. Click the
+
to open the network settings parameters.
2. Do one of the following:
•
Open
Virtual LAN
and enter the manual VLAN ID as directed by your local system
administrator.
•
Select
Enable LLDP
if your VLAN settings are configured to be discoverable.
Both options are shown in the following figure.
2.9 Configuring your firewall
If you have a firewall, the outgoing policy must be configured to meet BT Conferencing
requirements.
Procedure
1. Browse to:
http://www.btconferencing.com/downloads-library/apps/dolby-voice/
The target IP addresses, as well as the protocols and ports they use, can be found here.
2. Find the IT administrator guide section, and download the document.
3. The firewall information is in the required firewall settings section.
4. The Dolby Conference Phone uses Hypertext Transfer Protocol Secure (HTTPS) to access
for authentication, so make sure this can pass through the
firewall used by your organization.
2.10 Setting the phone display name
The display name on the phone will appear in the conference roster when the phone joins
conference calls, so this should be configured to a meaningful name.
•
Use one of these procedures to set the display name of the phone:
•
From the Dolby Conferencing Console software:
a) From Dolby Conferencing Console, select a device, and then click the
Edit device
configuration
button.
b) From
IP IPBX
>
Account
, drag
Display name
to the device configuration.
c) In the
Sip.Account.DisplayName
field, type a device name.
Configuration procedures
Dolby Conference Phone version 3.1 configuration guide for BT MeetMe with Dolby Voice
22 February 2017
14